You could always try tape. It might be expensive to replace if you have to change the whole piece so maybe something like super glue would work so that it doesn't show?
How about using silicon to hold it together? It will be a neater job than using duct tape, but might work better than trying to super glue the piece flush.
Isn't silicon just some kind of lubricant though? How would that hold the piece together? I just suggested super glue because it seems to hold plastic together well and is sometimes not noticable.
You mean like silicone caulking? That might be an option, and it would be water resistant, as well. I'll have to see if I still have some leftover in the shed.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Plate over the heater controls broke
It might be expensive to replace if you have to change the whole piece so maybe something like super glue would work so that it doesn't show?
Linear Mode
